K obsahu stránky

Electronics Replacement Set for Electric Guitar

  • For T-Style models
  • Hand-wired electronics kit with highest quality components, providing a significant improvement over standard electronics
  • Solderless plug-in wire connector for quick installation and easy pickup changing
  • Switch positions: 1: bridge, 2: bridge and neck (parallel = standard), 3: neck, 4: neck and bridge (serial = fat humbucker tone)
  • Made in USA

Delivery contents:

  • Volume control: 1x CTS 250 kOhm, Vintage Audio Taper (30%).
  • Tone control: 1x CTS 250 kOhm, Vintage Audio Taper (30%)
  • Thread length: 9.5 mm
  • Smooth axle (solid shaft)
  • 1 .047µF capacitor
  • 1 Oak Grigsby 4-Way lever switch
  • 1 Switchcraft 1/4" mono jack socket

Note: The 4-way modification requires a separate wire from the cover of the neck pickup (if it has a cover) to the shield; if you do not have this wire, you can cut off the connection between the cover and the eyelet and solder a separate wire to the cover.

  • K dostání od Leden 2023
  • Číslo produktu 556711
  • Prodejní jednotka 1 ks
  • Design Prewired Harness/Wiring Kit
  • Resistance Value 250 kOhms
  • Characteristic Curve Logarithmic
  • Thread Length in mm 9,5 mm
  • Tandem Poti No
  • Push/Push No
  • Solderless Yes
  • shaft type Smooth
  • Part Type Wiring Kit
  • Type Switcher
  • Colour Silver
2 666 Kč
Všechny ceny vč. DPH
Na skladě
1

11 Hodnocení zákazníků

4.7 / 5

Zpracování

6 Recenze

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
C
Fantastic Upgrade!!
CiaránH 13.03.2026
I installed this harness into the Harley Benton TE-170 Black Paisley Tele alongside La Brea pickups. Very easy to put together and install. Will take a bit of moving around to get it into place, especially if installing into a three way switch shaft. Keep in mind that the pots use the American metric measurements. This means that if the original pots and knobs are European made, you will need the correct tone/volume knob size to fit the Mojotone pot knobs. I resorted to sticking a piece a paper to hold down the knobs even though it was a screw fit. However, this is a fantastic upgrade and would recommend.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení