Allparts Semi-Hollow Wiring Kit

Not great, not bad.
After reading the other reviews I must add this:

- 2x Audio Taper + 2x Linear Taper pot. If you don't like how the pots behave, this is personal preference and you should have done your research before buying.
- There is a very noticable difference in turning resistance. The linear pots turn very "heavy", the audio pots turn very light. -> This feels weird.
- You need to buy correct braided wire seperately. The wire in the kit is not long enough and it's the wrong wire anyway, it's totally useless.
- There is no issue with the switch. The issue is with the nut. The switch has the wrong nut and this is not Thomann or Allparts fault. If you buy Switchcraft switch seperately it also has the wrong nut. They give you 1 flat nut, but you need a nut that goes "inside" the guitar. "Deep thread nut". -> Search for "Switchcraft SW-DKN-N".
- There is a paper with wiring schematic for a Les Paul guitar in the kit (not for ES335). Not a problem, there are very good schematics on internet anyway.

Conclusion:
1) The parts are good quality. But the set is incomplete: you need to purchase braided wire and the correct nut for the switch before you can use it!
2) The pots dont behave in the same way.
3) -> It's probably better to buy everything seperately, especially the pots.

Ce kit de cablage est destiné aux guitares type ES 335 (indiqué sur plan de montage ) Une Epiphone "The dot" est une type ES335 (voir description de cette guitare ) Le switch fourni dans ce kit a un filet de fixation trop court et impossible à fixer sur la table ! Quant à la qualité du fil conducteur : de la camelote Quant aux potos , idem : les potos tonalité sont trop courts (filet de fixation ) et un poto volume présentant un défaut (inutilisable ) Bref , cet article ne vaut rien J'ai dû racheter 3 potos et changer complètement de fil Belle perte de temps et d'argent Le shéma de montage oublie qu'il faut relier les potos volume et tonalité entre eux par la masse , sinon bruit de fond . CTS , OK All Parts , non , il ne m'en faut plus La fabrication d'une SG est prévue mais certainement pas avec la marque All Parts