K obsahu stránky

U - Rack Panel

  • 1.2 mm steel
  • Format: 19 " / 2U
  • Colour: Black
  • K dostání od Srpen 2008
  • Číslo produktu 214130
  • Prodejní jednotka 1 ks
  • Rack Units 2 U
  • Type 19"
121 Kč
Všechny ceny vč. DPH
Na skladě
1

322 Hodnocení zákazníků

4.9 / 5

Zpracování

95 Recenze

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
K
Thick and strong.
Karmo7 08.03.2020
I made my own I/O panel out of this.
It has i matte black finish, in case you are not a fan of glossy things.
It's made of steel. Strong and sturdy. No dents or defects were caused by drilling the holes. I fitted 24 type-d XLR sockets on this.
Zpracování
1
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
b
Simple, sturdy, does the job
bmatteo00 24.07.2026
Exactly what you'd expect from a blank rack panel — solid metal construction, fits perfectly in a standard 19" rack, no flex or rattling. Nothing exciting about it, but that's the point: it just works.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
I
The right one to fill the empty space..in your rack
I'mTheSoundGuy 23.10.2019
As I stated above, this 2 U panel is the perfect solution when you want to close a gap on you rack. I use it in an IEM/Wireless mics rack where I have 2 units left and it hides the cables inside the rack. Solid construction with no bending because of the 90 degrees dented lower side. Great product!
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
P
Good quality 2U panel and very strong
Pete-plays-guitar 25.04.2017
There is not a lot you can say about a 2U rack panel, but I will have a go.

One major thing (I think is major) is that the end of the strip top and bottom is bent over at 90 degrees with makes this a very stiff and strong panel, especially when combined wit the fact that is it a quite heavy gauge steel it is pressed from. Many rack strips have no bent edge which makes them flex and this starts to make the paint crack, so no problem with this one.

Once fitted int the rack, it is rock solid. I would also have no problems in drilling into this strip for fitting plug sockets etc.

Highly recommended
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení