Harley Benton B-650 Black Progressive Series

Hi! I've purchased this bass about a week ago. Gotta say for the price you're getting a decent beginning 6 string bass. Of course it's a cheap instrument but like I said for the price tag you can't go wrong. Don't expect a Fodera. Although, what I don't understand is why the fret board is unfinished? I could prolly fit another 2 frets with no problem like literally 2cm of wood is hanging out. Not sure about that. Also, the fret buzz is terrible! Could've been at least set up or tuned! However, if you're looking out to get a 6 string go get and grab it.

I've only ever played my trusty old 4 string basses, so this was a first 'toe in the water' into the land of both extended range and 'budget' basses for me. Initially I rather dismissed the lower cost end of the market after listening to the views of other musicians with more experience than me of 'entry level' priced instruments, until I stumbled upon BassTheWorld's review of the B-650 on the usual video site everyone knows, got intrigued and then checked out the reviews on here.

Although I used to gig in the past, nowadays I mainly work on recording my own tunes at home, usually overlaying multiple bass parts in a looper or DAW. A six string bass seemed a good idea to access the extended range and make separation in the mix of parts a bit easier.

Ordered Thursday and it was was delivered to my door in Scotland the following Wednesday. The outer box was pretty badly damaged in transit but Thomann had double boxed with plenty of air pillow packaging protection, so the inner box and bass were totally unscathed. I'd also communicated a few times before and during ordering via email and online chat and found Thomann to be efficient and courteous. Full marks to Thomann so far then, as far as I'm concerned.

The bass arrived without any flaws in the finish, a lovely straight neck, intonated and with a medium action. Nut slot depth just right (surprising to me for a factory instrument) and it was even very nearly in tune too. Frets are level with no sharp edges and the bass is fairly lightweight. The neck is very thin in profile, which happens to be my preference and the width very manageable due to the 16mm string spacing.

My current 4 stringers are standard 19mm, or 17.5mm at the bridge in the case of my old Rickenbackers, so I wasn't sure how I'd get on with the narrow spacing, but the 16mm or so of the B-650 actually feels very comfortable. I prefer a low action and was able to lower things a bit without fret buzz. That also required a bit of intonation adjustment with the, unfamiliar to me, monorail bridges, but once I (eventually) saw the angled grub screw partially hidden beneath the string on the black bridge pieces, that was straightforward.

A big selling point for me was the active passive pull pot, a tone knob which worked in passive mode and the bass's ability to still work even without a battery in. I was quite surprised to find that in passive mode not only does the treble roll off work but the other tone knob works as a bass roll off. Quite surprising features considering even some expensive basses don't do some of these things.
Volume knob has a smooth gradual decrease, but the tone knobs are subtle in effect over most of their travel with a big change over the last few degrees of rotation. I expect that's due to the chosen taper type of the pots, but there's plenty info online about that if you want to change the pots if you don't happen like that.
The supplied factory strings are perfectly usable, later I'll likely change them for D'Addarios of the same gauge,

The sound, as others I think have said, is 'modern' but the actives are quite transparent and noiseless. I usually lean towards using the passive mode (if there is one) on active basses, but here the active mode, to my ears, doesn't have the 'too clean' harshness I find with some actives, so it's quite usable if used. The bridge pickup is quite 'middly' in tone and you can get quite an aggressive growl from it with it's trebly edge. The neck pickup is smoother sounding and also 'fat'. The blend pot gives the expected 'scoop' at the centre detent but it occurs at quite a narrow window of rotation.
The pickups arrived at the bottom of their travel on mine, but set at the correct distance for the action the bass came with. If you want to try a super low action, depending on how you approach that, it may require a little work there. Though taking into account the cost of the bass, I don't regard that as a criticism here, that would be totally unreasonable, rather more of something to potentially be aware of if that is common (all basses at any price will have some variation).
String tone and volume balance I found to be quite even across strings.

The hardware isn't going to be the most expensive at this overall price point obviously, but it all works and the fundamental body, neck and frets are just lovely. Certainly considering the cost of the bass to begin with, there's also scope for modders to spend a bit more on it, upgrading bits if desired or simple individual fettling to preference of what's already there and end up with a very nice bass at still a modest price.
For ¤158 I'm very impressed indeed and couldn't be happier.

The BassTheWorld's video review I referred to earlier, having now experienced the bass, I agree with 100%. It's just plain fun and one of those pick it up and can't put it down instruments. I'm delighted with it and simply very glad I bought it. What more can I say.