Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
A
Simple corners
These are pretty simple corners. I use these on my YGON pedalcases I make. Rounding off the edge with radius 5mm, they fit perfectly!
Note that the holes are not always on the exact position. If you drill holes for your screws, make sure you use this corner when assambling. And not another one. They're different.
Note that the holes are not always on the exact position. If you drill holes for your screws, make sure you use this corner when assambling. And not another one. They're different.
0
0
Ohlásit hodnocení
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
r
Exactly what I needed
Used to raise a pedal board higher off the ground. Sturdy and easy to fit.
0
0
Ohlásit hodnocení
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
R
not much to say, piece of metal that is doing it's purpose.
I thought it wold be smaller because of word "small" in description, but nevertheless....
I thought it wold be smaller because of word "small" in description, but nevertheless....
0
0
Ohlásit hodnocení
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
s
Protect's corners
I used this for some custom pedalboards I built. The case corner small did the job for me. You can see the pedalboards here: https://www.facebook.com/tonepedalboards
0
0
Ohlásit hodnocení
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
RS
Great
Protects the corner for your case perfectly.
0
0
Ohlásit hodnocení